SMTA – Manual Cleaning of PCB Assemblies – Successful Tricks of the Trade

When:
September 16, 2019 @ 6:30 am – 8:00 am
2019-09-16T06:30:00-07:00
2019-09-16T08:00:00-07:00
Where:
webinar

https://www.smta.org/webinars/#cleaning

By Bob Willis

$25 for members / $95 non-members

After rework, modification or second stage assembly cleaning may need to be considered. Ideally a no clean flux, gel or solder paste should be used to avoid the need to clean selected areas. If manual cleaning is to be conducted every effort should be made to use materials or application methods that result in the minimum residues from the soldering process.

Planning and training staff in manual cleaning are very important to get the best possible result visually and to maintain product reliability. This is one of the first training sessions to cover manual cleaning of board assemblies, highlighting the problems and solutions to manual cleaning.

Topics include:

  • Why clean
  • Material selection
  • Manual cleaning techniques
  • Testing cleanliness
  • Inspection requirements
  • Component compatibility
  • Reliability test techniques
Comments are closed.

Powered by WordPress. Designed by WooThemes