CBM – Using Motor Current Signature To Detect Number Of Cracked Rotor Bars In Induction Motors

When:
April 2, 2020 @ 8:00 am – 9:00 am
2020-04-02T08:00:00-07:00
2020-04-02T09:00:00-07:00
Where:
webinar

https://register.gotowebinar.com/register/1217586387505335564

By Mohamed Wahba

Broken/Cracked rotor bar/s is one of the commonly encountered induction motor faults that may cause serious motor damage to the motor if not detected timely. Past efforts on broken rotor bar diagnosis have been focused on vibration analysis and current signature analysis using spectral analysis . These methods require accurate slip estimation along with high resolution data , and very pericise judgement of severity to confidently pull out the motor to the workshop with no doubt . This presentation will not only focus on collecting current signature , but also will cover the analysis part of spectral data to determine the number of cracked/broken bars along with the severity level and needed corresponding corrective actions . This will be clearly shown through two real case studies in my plant for two 1.2 MW induction motors. 

Learning Takeaways- 

  • What is Motor Current Signature and how to use it effectively to complement vibration diagnosis
  • How to Collect data using MCS 
  • Analysis of cracked/broken rotor bars and detecting the number of defected bars through MCS
Comments are closed.

Powered by WordPress. Designed by WooThemes